Universal Parts 12 Volt 6 Amp YTX7A-BS Battery - Maintenance Free Dry AGM w/Acid Pack. fits full-size scooters, mopeds, ATVs, dirt bikes, motorcycles, off-road vehicles and much more.**Note: This product is a ORM-D (Other Regulated Item, Domestic) regulated item and ships via FedEx Ground to the lower 48 states only. Length: 5.90 inches (150mm) Width: 3.40 inches (86mm) Height: 3.70 inches (94mm) Includes Acid PackCCA (cold cranking amps): 90Uses M6x12mm Battery Terminal Bolt Set Set-Up Instructions All AGM battery electrolyte containers are not the same. Each contains the proper amount of electrolyte for its specific battery. Before filling, read the electrolyte handling instructions and precautions on the label. Do not smoke when activating a battery or handling battery acid. Always wear plastic gloves and protective eye wear and be sure to read the Battery Safety section in this manual. The following seven steps should be used to activate an AGM battery: 1. The battery must be out of the vehicle and placed on a level surface. 2. Remove electrolyte container from the plastic storage bag. Remove the strip of caps. Put the strip aside as you will use it later to seal the battery cells. For battery filling use only the dedicated acid container that comes with the battery as it contains the proper amount of electrolyte for that specific battery. This is important to service life and battery performance. Do not pierce, or otherwise open the foil seals on the electrolyte container. Do not attempt to separate the individual electrolyte containers. 3. Place the electrolyte container with the foil seals facing down into the cell filler ports on the battery. Hold the container level and push down to break the foil seals. Electrolyte will start to flow into the battery and air bubbles will be seen inside the container. Do not tilt the electrolyte container. 4. Check the electrolyte flow. Keep the container in place until it empties compl…contact us for add'l info.